EPISODE CLINIC
Ko

Layered Re2O

Layer Re2O

Layer Re2O
#Layer Re2O#Re2O#X-injector#Cure Jet

This is a treatment where one bottle of Re2O is injected at different depths.

Layer Re2O

Layered Re2O


Skin texture and tone differ in the upper dermis, density and elasticity in the dermis, and sunken areas just below the dermis. It is difficult to inject collagen evenly across all these depths using a single method.

Layeri-Lituo is made by mixing 1 bottle of Re2O (150mg) with 6cc, and then A treatment in which the contents are divided into needles, cannulas, and X-injectors and injected separately, layer by layer, at different depths.Layer Re2O III uses a Cure Jet to inject small-particle Re2O Fine.

The purpose is to maximize the effect with a single Re2O. We proceed with four programs depending on which equipment is used and which areas are injected.

The ingredients and specifications of Re2O are based on data provided by the manufacturer (Humedics).
Human tissues are managed in accordance with the Act on Safety and Management of Human Tissues, etc.

time taken
time taken
40-60 minutes
Varies depending on the program
pain
pain
Proceeding after anesthesia
Pain Level: 2/5
recovery period
recovery period
Able to resume daily life on the same day
Swelling and bruising last for about 1 week
Duration
Duration
3-6 months
Individual differences
treatment interval
treatment interval
4-week intervals
Recommended for the first 3 sessions

About Layered Re2O

Why Lituo?
Shall we divide it up and put it in at each depth?

There is a depth suitable for every skin concern, and
There is a suitable method for each depth.

Purpose by Depth epidermis subcutaneous fat upper dermis Skin texture, tone dermis Density, elasticity Deep within the dermis Localized fine lines, scars Just below the dermis Wide range support
01

The injection depth must vary depending on the problem area.

Skin texture and tone upper dermis, density and elasticity are dermis, localized fine lines and scars are Deep within the dermisPut it in.

Areas that require even treatment over a large surface area Just below the dermisSpread evenly and inject.

* For the objectives by depth, the 2026 Re2O academic presentation materials were referenced.

Injection depth by treatment method Cure Jet upper dermis X-injector dermis You guys Deep within the dermis cannula Just below the dermis
02

The injection depth is determined by the treatment method.

Cure JetIt is a method of injecting medication using pressure without needles. It spreads thinly on the upper layer of the dermis.

X-injectorSeveral needles penetrate to a predetermined depth and inject equal amounts into the dermis. You guys Even when using it, the same amount can be injected into the dermis, but there is some degree of pain.

cannulaIts blunt tip allows it to pass just beneath the dermis and be inserted in a wide, spread-out manner. It minimizes pain and bleeding.

CureJet is a needleless injector from Vaz Biomedic.

Mixing and distribution Layer Re2O II Standard Re2O 150mg PDRN 3cc Non-bridge HA 2.5cc Lidocaine 0.5cc 6cc Mixture X-Injector 4cc The whole face 2cc cannula cheekbones
03

Widely used with a single product

Since Rituo is a powder product, it is opened right in front of your eyes. PDRN 3cc, non-cross-linked hyaluronic acid 2.5cc, lidocaine 0.5ccMix with to make 6cc. The process is carried out to dissolve evenly without lumps or air bubbles.

For needles, cannulas, and X-injectors, use this mixture as is. For the CureJet, mix the fine-particle Re2O Fine with 3cc of PDRN and 1cc of lidocaine to dilute it to 4cc. Since it is a pressure-based injection device, the concentration must be diluted slightly to ensure better absorption.

Open one bottle per person and use. Mix immediately after opening.

Program

Layer Re2O program

Re2O, Layer Re2O I, II is 1 bottle of Re2O (6cc),
Layer Re2O III is performed with 1 bottle (4cc) of Re2O Fine.

Re2O

Re2O

Inject into the entire face with a needle.

6cc needle
  • You guysThe whole face6cc

Layered Re2O I

Layer Re2O I

Inject into both cheeks with a both cheeks and into the cheekbone with a cannula.

Needle 4cc2cc cannula
  • You guysboth cheeks4cc
  • cannulacheekbones2cc

Layered Re2O II

Layer Re2O II

It is injected into the entire dermis of the face using an X-injector, and into the anterior cheekbone using a cannula.

X-Injector 4cc2cc cannula
  • X-injectorThe whole face4cc
  • cannulacheekbones2cc

Layered Re2O III

Layer Re2O III

Using one bottle of Re2O Fine, inject it into the upper dermis of the entire face using CureJet.

CureJet 4cc
  • Cure JetWhole face, Re2O Fine4cc

Under-eye program

Re2O Fine

Re2O Fine

We perform the treatment only on the under-eye area using one bottle of Re2O Fine.

2cc cannula
  • cannulaunder the eyes2cc

The bar width is based on 6cc.
Layer Re2O III is prepared by mixing 3cc of PDRN and 1cc of lidocaine with 50mg of Re2O Fine to make 4cc.
For the under-eye program, mix 50mg of Re2O Fine with 1.5cc of non-crosslinked HA and 0.5cc of lidocaine to make 2cc.
The amount used per device may vary depending on skin thickness and the area.

How It Works

Injection methods by depth

1
Cannula injection epidermis Dermis subcutaneous layer Just below the dermis cannula

with a cannula
Widely just below the dermis

Very small amounts are injected using a 25–27G cannula, passing just beneath the dermis. Since the anterior cheekbone is a broadly recessed area where blood vessels pass, injection is performed via a cannula. By using a single entry point and spreading the injection in a fan shape, bruising and bleeding are minimized.

2
Needle injection epidermis Dermis subcutaneous layer Deep within the dermis You guys

with needles
One point deep in the dermis

Very small amounts are injected into individual points using a 30–32G needle. Small areas, such as localized fine lines or scars, can also be injected separately.

3
X-injector injection epidermis Dermis subcutaneous layer dermis X-injector

with X-injector
Evenly in the dermis

Multiple needles are inserted to a predetermined depth, and equal amounts are administered. If the amount of leakage or pain changes, the depth is checked again.

4
CureJet injection epidermis Dermis subcutaneous layer upper dermis Cure Jet

with CureJet
Thinly on the upper dermis

Inject the thinly mixed Re2O Fine using pressure without a needle. Move it while keeping it against the skin to apply it densely across the entire face.

Treatment Areas

Layer Re2O treatment area

For every program
The injection site is different.

Layer Re2O treatment Areas: Front cheekbones, both cheeks, under eyes
cheekbonesCannula(I, II)2cc
both cheeksNeedle(I)4cc
under the eyesCannula, Re2O Fine2cc
The whole faceNeedle (Re2O), X-Injector (II), Cure Jet (III)4~6cc

The anterior cheekbone is a widely sunken area where blood vessels pass, so injections are made using a cannula.
For the upper area, the injection is administered only up to the rim of the bone below the eye. Since the skin under the eyes is thin, the treatment is performed separately using Re2O Fine, which has small particles, with very small amounts injected both above the periosteum and beneath the dermis.

Product

Product and mixing standards

I wrote down the product used and the mixing ratio exactly as they are.

Product Name
Elavie Re2O (Elravie Re2O), Humedix
classification
Human tissue (acellular allogeneic dermis, hADM)
standard
Re2O 150mg, average particle size 82.3µm
Re2O Fine 50mg, average particle size 49.8µm (Layer Re2O III, Under-eye Program)
Basic Mix
Re2O 150mg + PDRN 3cc + Non-crosslinked HA 2.5cc + Lidocaine 0.5cc (Final 6cc)
Re2O, Layer Re2O I, II
CureJet Mixing
Re2O Fine 50mg + PDRN 3cc + Lidocaine 1cc (Final 4cc)
Layer Re2O III
Under-eye mixture
Re2O Fine 50mg + Non-crosslinked HA 1.5cc + Lidocaine 0.5cc (Final 2cc)
treatment instruments
25~27G cannula, 30~32G needle, X-Injector, CureJet
Injection depth
CureJet upper dermis / X-Injector dermis / Needle deep dermis / Cannula just below dermis / Above the periosteum and below the dermis beneath the eyes
Usage principles
1 bottle per person. Use within 4 hours of mixing. Do not mix with cross-linked hyaluronic acid.
treatment interval
3 times at 4-week intervals, under-eyes every 8 weeks
certification
Raw materials certified by AATB (American Association of Tissue Banks), FDA approved, and MFDS authorized.
Storage, expiration date
Store at room temperature (1–30℃) / Shelf life: 5 years from date of manufacture

Recommended For

I recommend this to people like this.

skin texture and elasticity
Those who are worried about both

The skin on the front cheek
People who look thin and sunken

I have received Lituo, but
For those who were dissatisfied with the skin surface

The skin under the eyes is thin and
The person who looks faded

The EPISODE proceeds like this.

The Episode Difference

Why It's Different

These are the things to keep in mind when proceeding with EPISODE Layered Two.

01

Looking at skin thickness
Divide the amount.

Pre- treatment consultation

While each program has a standard amount for each device, the same amount may not be suitable for individuals with thin skin versus those with thick skin. Before the treatment, we assess the thickness and degree of hollowness in each area and adjust the amount for each device accordingly.

02

One bottle per person
It opens right before your eyes.

Elavie Re2O Authenticity Verification Center

Open the authenticated Rituo in front of the patient and mix immediately. Do not divide a single bottle among multiple patients, and do not use the mixture after 4 hours have passed.

03

All in one place
I do not put it in.

Needle and cannula treatment

If a large amount of Lituo accumulates in one spot, a palpable lump may form. Distribute very small amounts across multiple points, and further reduce the amount injected at once for thin areas like under the eyes.

04

If you keep a record
The changes are more visible.

Online treatment Report

The attending physician's comments on today's treatment, the amount inserted by device, and the remaining number of treatment are saved in an online report, allowing you to review past records at any time.

Care Process

Layer Re2O proceeds through this process.

01

Anesthesia process

02

design

03

treatment

04

Modeling pack

05

homecoming

06

Provision of treatment report

Some processes will be changed for the promotional treatment.

Notice

Post- treatment precautions

  • 1

    Swelling, redness, and a fine nodular sensation may occur at the injection site immediately after the treatment. In most cases, these subside within 24 to 48 hours.

  • 2

    Bruising may occur from the injection, but it usually heals within a week.

  • 3

    Small red spots may appear on the area treated with CureJet. They will fade within a few days.

  • 4

    Please wash your face gently with lukewarm water starting 3 to 4 hours after the treatment, and apply makeup starting the next day.

  • 5

    Please avoid saunas, steam rooms, and excessive exercise for one week after the treatment. Swelling and bruising may worsen.

  • 6

    Please pay attention to moisturizing to prevent your skin from drying out. Please avoid irritating treatments like scrubs for the time being.

  • 7

    If pain worsens or your skin turns purple or white 2 to 3 days after the treatment, please contact the hospital immediately.

  • 8

    LayeriTuO is performed 3 times at 4-week intervals. The Re2O Fine under-eye treatment is spaced at least 8 weeks apart.

  • 9

    Please contact the hospital if swelling or redness persists, or if a palpable nodule remains.

Price

treatment price

Re2O Fine

Re2O Fine 1 box + skin glow injection 3cc

1 time
440,000 won