EPISODE CLINIC
Ko

Eye Thermage FLX

Eye THERMAGE FLX

Eye THERMAGE FLX
#EyeAreaElasticity #Eyelid drooping #HighFrequencyLifting

High-frequency lifting specifically for the eye area

Eye THERMAGE FLX

Eye Thermage FLX


Eye THERMAGE FLX is a non-invasive radiofrequency lifting procedure that delivers monopolar RF energy deep into the skin to immediately contract loosened collagen fibers and promote the production of new collagen over the following months. It is treatment on the skin surface without the use of needles, delivering heat to the dermis and the layers below while protecting the epidermis with cooling.

The 4th generation FLX combines AccuREP™ technology , which reads skin resistance and adjusts output for each shot (REP), with omnidirectional vibration and cooling pulses. The entire face is treated using a 4.0cm² Total Tip , while the eye area and eyelids are treatment using a 0.25cm² Eye Tip .

Loading treatment information.

Why Thermage FLX

Cool the epidermis,
It warms the inside.

Keep the outside cold and the inside hot to apply heat only to the necessary depth.

Point 01

Widen the skin
Heat it all at once.

Unipolar radio frequency from the dermis to the subcutaneous fat layer Heat a large volume at once.. Because the surface where the tip touches is protected by cooling and heat accumulates underneath, the outside is the coldest and the inside is the hottest Reverse temperature distributionIt happens.

  • Epidermal cooling and dermal heating proceed simultaneously
  • Immediate contraction of collagen fibers, followed by induction of regeneration
  • non-invasive method that does not use needles
treatment Tips stratum corneum epidermis dermis subcutaneous fat The epidermis is protected by cooling Heat down to below the dermis Inverse Thermal Gradient
AccuLab Energy Transfer Diagram

Point 02

Read again for every shot,
I'll readjust it.

THERMAGE FLX delivers energy in REP (shot) units. AccuREP™every time right before sending a REP Send the tuning pulse first. It is an automatic adjustment algorithm that measures the impedance at that location—that is, the electrical resistance of the skin—and regulates the energy release value. Since skin resistance varies by body part and person, even at the same level, this process must be gone through. Consistent energy for each treatment areais delivered.

  • AccuREP

    Tuning pulse every REP (shot)

    Automatically measures impedance and adjusts the energy release value accordingly.

  • Cooling

    3-stage cooling

    It protects the epidermis by dividing it into before, during, and after irradiation.

Point 03

Collagen that has been heated
It changes twice.

Collagen consists of three twisted strands Triple helix structureis. When heat is transferred here, water molecules separate from the collagen, causing the helix to unravel, and in that process The fiber contracts.. Therefore, immediately after the treatment , the dermis and fibrous septa tighten together.

  • Contract

    Initial response, immediate collagen contraction

    As collagen denatures, the dermis and fibrous septa contract.

  • Remodel

    Secondary regenerative response, collagen remodeling

    Over time, new collagen accumulates and density increases.

heat Collagen Triple Helix Degenerated, contracted collagen When heat is applied, water molecules separate and the helical structure unravels.

Treatment Tip

We will proceed with iTip.

Eye THERMAGE FLX uses only the 0.25cm² eye tip.

THERMAGE FLX eye tip 0.25cm² THERMAGE FLX eye tip side

iTip

0.25cm²eyelids, eye area

225 shots, 450 shots

Used for Eye THERMAGE FLX

THERMAGE FLX Total Tip 4.0cm² THERMAGE FLX Total Tip side

Total Tips

4.0cm²The whole face

300 shots, 600 shots, 900 shots

Used on THERMAGE FLX

The treatment tip is a single-use consumable used only once per person.
The eye tip has a surface area that is about 1/16th that of the total tip, so it is used on narrow and curved areas such as the upper eyelids and under the eyes.

How It Works

Mechanism of Action of Eye THERMAGE FLX

1

When heat stimulation is applied, in collagen fibers
Water molecules separate and collagen contracts.

Principle of Operation Stage 1
2

As collagen builds up over the next few months
The second playback response follows.

Operating principle, 2 stages
3

New collagen is produced and elasticity increases
The effect lasts for about 6 to 12 months.

3-step operating principle

After Treatment

Flow of changes after the treatment

Immediately after the treatment

Collagen fibers that react to heat
It starts to contract.

2-4 months

As new collagen is created
The elasticity and fine lines around the eyes gradually change.

Around 6 months

Collagen reformation continues
This is the time when changes become most pronounced.

Around 12 months

As a period during which the effect is maintained,
Consider the following treatment as needed.

Eye THERMAGE is a treatment where the changes become fully visible a few months after the treatment .

At first, you may feel a slight pulling sensation around your eyes, and as new collagen is produced, your eyelids and under-eyes will gradually change.

Treatment Areas

THERMAGE FLX treatment area

The treatment is performed using tips suitable for each area of ​​the face.

THERMAGE FLX treatment area
forehead, temples, entire cheek Total Tips
The entire neck Total Tips
around the eyes iTip

The treatment can be performed on the entire face, including the eyelids, the eye area, and the forehead.
Proceed with the eyelids and eye area using the Eye Tip, and then proceed with the entire face, including the forehead, using the Total Tip. Use both types of tips together during this process.

Recommended For

I recommend this to people like this.

heavy eyelids
Those who have started to feel it

Fine lines around the eyes
Someone who is concerned

In one day without a recovery period
Those who want to finish

With original equipment
Those who want to undergo the treatment

Not only the results, but even the difference in experience

The Episode Difference

Why It's Different

Every process has its own reason for the EPISODE.

01

You need to know your skin condition accurately.
The treatment can be performed appropriately.

Skin analysis before the treatment

Before the treatment , we check skin thickness, fat distribution, and the direction in which sagging began. We begin after determining which area to treatment and how.

ANALYSIS

02

Check the genuine tip,
The treatment is performed with appropriate intensity.

Verify genuine treatment tips

Before the treatment , verify the authenticity of the tip and open it. Lower the energy level or It does not sweep quickly, but adjusts the level according to the heat sensation you feel.

TECHNIQUE

03

Pain management
It is taken as part of the treatment.

Pain management

Prepare various pain management methods such as anesthetic cream, pain-relieving IV drip, local anesthesia, and sedation, and We allow you to select a method that suits the type of treatment and the patient's condition, ensuring a comfortable experience.

COMFORT

04

If you keep a record
The changes are more visible.

Online treatment Report

Online report of the attending physician's comments on that day's treatment, treatment details, and remaining treatment . I have saved it for you so that you can check your past records at any time.

RECORDS

Care Process

Eye THERMAGE FLX proceeds through this process.

01

Cleansing

02

Anesthesia process

03

treatment

04

Room temperature ampoule pack provided

05

homecoming

06

Provision of treatment report

Some processes will be changed for the promotional treatment.

Notice

Precautions before and after the treatment

  • 1

    Please remove metal accessories such as necklaces and earrings before the treatment , and be sure to remove contact lenses when treatment around the eyes.

  • 2

    The treatment is difficult if you are using an implantable electronic device, such as a pacemaker, or if you are pregnant. Please be sure to inform us during the consultation.

  • 3

    You will feel a burning sensation during the treatment . If it is unbearable, please let us know immediately.

  • 4

    You can wash your face and apply makeup immediately after the treatment , and no special recovery period is required.

  • 5

    Redness, warmth, and mild swelling may occur for a few hours after the treatment , and usually subside within a day.

  • 6

    Please avoid drinking alcohol, saunas, steam rooms, and strenuous exercise on the day of the treatment . This may prolong the sensation of heat and swelling.

  • 7

    Changes will appear slowly over 2 to 6 months. During this time, please make sure to pay attention to moisturizing and sun protection.